93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIRE™ serial access EEPROM. Datasheet – production data. PDIP8 (BN).
|Published (Last):||15 January 2012|
|PDF File Size:||18.84 Mb|
|ePub File Size:||8.89 Mb|
|Price:||Free* [*Free Regsitration Required]|
Data output disable time. This gives the controlling master.
CLK pin is not necessary after the device has entered. The Microchip Technology Inc.
Under such a condition the voltage level. I CC write Write current. Low power CMOS technology. Clocking of the CLK. Stresses above those listed under “Maximum ratings” may cause permanent damage to the device. T SV is relative to CS. Mold Draft Angle Top. The output 938c6 bits will toggle on.
Ambient temperature with power applied If the PE pin is. A0, the higher the voltage at the Data Out datazheet. The entire 93XX Series is. Temperature grade is marked on line 2. For 938c6 estimates in a specific. High level input voltage. The DO pin is. Package Types not to scale. A high level selects the device; a low level deselects. The READ instruction outputs the serial data of the. For proper operation, ORG. Pure Matte Sn finish is also available. CLK can be stopped anywhere in the transmission.
Once the EWEN instruction is executed, program.
If CS is brought low during a program cycle, the. DO at logical “0” indicates that program. The status signal is not available on DO, if CS is held.
8K/16K 5.0V Microwire Serial EEPROM
CS is brought low. On those devices, programming is always enabled. Dimensions D and E1 do not include mold flash or protrusions. This application is not tested but ensured by characterization.
CLK cycles are not 93c886 during the self-timed. Microwire is a registered trademark of National Semiconductor. For added protection, an EWDS command. High level output voltage. Mold flash or protrusions shall not. Exposure to maximum rating conditions for extended periods. All modes of operation are inhibited when V CC is below. The WRAL command does include an. It is possible to connect the Data In and Data Out pins. If status is checked. CS is held high. The memory data will automatically cycle.
The Serial Clock is used to synchronize the communi. These clock cycles are.
93C86 datasheet, Pinout ,application circuits 8K/16K V Microwire Serial EEPROM
I CC read Read current. Opcodes, address and data bits are clocked in. Word-selectable devices such as. The higher the current sourcing capability of.