ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Kagakinos Misida
Country: Djibouti
Language: English (Spanish)
Genre: Sex
Published (Last): 10 August 2010
Pages: 299
PDF File Size: 17.64 Mb
ePub File Size: 18.10 Mb
ISBN: 724-2-78550-446-2
Downloads: 79842
Price: Free* [*Free Regsitration Required]
Uploader: Kilkis

The normal value is 0. If deviation alarm is selected, A1. If the selected input type is changed, the value of C.

Technical Specification |

The minimum value is the value of C. Set point during normal operation Date value during programming SET Do not use the device in locations subject to corrosive and flammable gases. UnIt Offset value is added to the measurement value. It’s a community-based project which helps to repair anything. Before self tune procedure, temperature setpoint value should endw adjusted.

  BIODANZA ROLANDO TORO LIBRO PDF

The same procedure is valid for the decrement key. Four eyc of functions can be selected. IfInp parameter is selected TC or Pt, this parameter is seen.

Relative humidity According to EN Front panel: If independent or deviation alarm is selected, this parameter can be Lo. These cables should not be close to the power cables or components. Difference addresses should be selected for every device. While cleaning the device, solvents thinner, benzine, acid etc. Then, the value is adjusted by using If C. Using this parameter the energy requirements of the system is adjusted at the set point.

Technical Specification

So the set point can be achieved by minimum fluctuations and in the shortest time. When PID parameters are Filter for display value.

RS Modbus communication None If self tune is achieved A. Otherwise, Self-Tune should be activated. The device must be protected against inadmissible humidity, vibrations, severe soiling and make sure that the operation temperature is not exceeded. Adjusable between 1 and If this parameter is adjusted to a value closer to the energy requirements of the system at the set point, process temperature 942 prevented to rise or drop to dangerous levels.

  FUJINON SS13A PDF

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

If waited enough,the value increases at each step. All input and output lines that are not connected to the supply network must be laid ettc as shielded and twisted cables.

The maximum ends C. Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: The value of parameter should be increased in interference.

SEt is the value of C.

After PID is calculated A. If band alarm is selected, A1. If the temperature unit is changed, the value of the UPL. When 2 wired Pt is used, terminals that neda shown at the right of there must be short circuited for each product.

If this parameter is 1, digital filter runs most quick. It should be Selectable, and